Tips for @#$@ lung Dynavap users?
A few tips:
•Take the Vap apart to clean it - the whole put it in the tube and shake it shit doesnt clean the end of the condenser which is what causes one of like 10 air flow restrictions.
•Dont use the rubber mouth piece, again - smaller air hole.
•In a ZVS 12v6A, you gota leave it in 1-3 sec after the dbl click to get it hot enough to vape correctly.
Going to buy a dave mod glass stem. This will help for using the ZVS and further remove the reduced air flow.
OCD/RELIGIOUSLY CLEAN YOUR DYNAVAP! IT DOESNT WORK THE SAME WHEN CLOGGED IN ANYWAY SHAPE OR FORM!
*Going back to the best hits ive had in a looooong time.... lol*
•If you are using a home made version and being jank as @#$@ like me currently, make sure you have full power to the power circuit before you connect it to the ZVS circuit.
• Do not leave your ZVS connected for more than 15 seconds at a time if you can help it. IT WILL SMOKE AT 3 MINUTES! (went to clean the damn vap cap and forgot it running lol)
^Im going to be building a switch, was just wanting to test it first.
• Default coil design works, make sure to pack the herb down a little bit so that it is not near the end cap. Like visibly lower than the top of the ti tip. This also helps good air flow get in. ( I was clogging the air path with to much herb at the end of the tip)
Sign in or register to add a comment.
Add a Comment
Welcome to Vape Life Forum!
Crafty & Mighty
Butane / Torch
Buy / Sell / Trade
Edibles & Topicals
Portable Dab Rigs
Tips & Guides
Ghost MV1 Usage Guide & Tips For Best Performance
Firefly is fatally flawed. Users beware. (And they don't offer service)
Firefly 2 Usage Tips & Tricks Video
New Dr Dabber Aura / Aurora Mouthpiece Tips
Promo Codes & Deals
Terms of Service
Created with PlushForums
© 2018 Vape Life Forum