• lazylathe
    282


    First extend the thermocouple a few mm's and then try again.
    What you can also do is add a round screen to the bottom of the glass vial, slightly more mass.
    Another mod is to use an EVO ELB, remove the solid ring and trim so the metal sleeve covers the bulb.
    This adds even more mass and you will be adjusting the temps DOWN to stop combusting!

    Takes a bit of practice to get the amount of mesh right just to give it that extra boost!

    Also, I did not watch your stream yet...
    But from personal experience it takes a while to properly heat soak.
    Load your bowl, drop the light on and turn on.
    Wait for the red dot to start blinking and just wait some more, if you take a hit now it will go solid again and your hit will suck...
    I like to give it a solid minute or two before the first hit and go slowly, always watching the blinking light.

    Long, slow draws are what works best, 30 seconds plus of gentle inhaling.
    It really is a great vape but takes some effort to get the best results.
  • LabPong
    889
    Long, slow draws are what works best, 30 seconds plus of gentle inhaling.
    It really is a great vape but takes some effort to get the best results.
    lazylathe

    30 second draws.......holy Jacques Cousteau/Mark Spitz/Micheal Phelps :strong:
  • lazylathe
    282


    Practise makes perfect bro!!
    Close on 20 years a herb smoker and last 10 or so has been strictly vaping. I was a swimmer when I was younger so that definitely helps!!
  • ChlorophyllMan
    236
    @VapeCritic So yeah, if you remove the glass bulb cover and use a wooden toothpick or something to nudge the wire sensor away/down from the bulb then the Aromed will run hotter. You can actually combust if it's set too far away so see how you go. Replace the glass cover carefully or you'll nudge the sensor again accidentally.
    I'm hoping to join you on the stream but hope it goes well if I can't!
    Also, regarding stirring, if you set the flexible arm in the correct position BEFORE you place the heater onto the bowl then you can just lift up the entire Aromed unit from the bowl when you need to. This avoids unnecessary further bending and stress on the glass pieces. This is the best tip I have for ease of use of the Aromed and will hopefully save you from breaking any glass dude!
    Good luck bro :up:
12Next
bold
italic
underline
strike
code
quote
ulist
image
url
mention
reveal
youtube
tweet
Add a Comment

Welcome to Vape Life Forum!

Sign up free for full access to this site.