• VapeCritic
    13.1k
    G43 VAPORIZER QUICK START GUIDE

    CLICK HERE to get added to the G43 wait list if you don't have one!

    9megc6nuoah230cl.jpg

    These instructions apply to the Wismec P80 mod with MyEvic firmware installed. Please see the official G43 thread for user reviews and a ton of information on this vape.

    Step 1) Connect components – Screw the RDA connector onto your Mod and connect the other end of the black wire to the heater wire.

    Step 2) Load herb chamber – Pull out the basket screen to access the herb chamber, then load it 20% to 90% full loosely with ground up herb (any consistency). Then, to prepare for vaping, insert the G43 slide into any 18mm glass rig.

    Step 3) Start the heater – If your Mod is locked, click the power button 5 times quickly to unlock. Adjust power level (watts) by pressing the two small + and – buttons (start at 11 watts). Press the power button briefly to engage the heater. When powered-on the LED lights on the side of the Mod will glow red continuously. After vaping, press the power button once to turn off the heater.

    Step 4) Wait 3 minutes and start vaping – The G43 heater will take approximately 3 mins to reach the optimal temperature. Draw at a brisk pace for 5 to 10 seconds and pull the slide to act as a carb. Every two draws remove the basket screen and quickly stir your herb with the included pick tool to ensure even vaporization. Do not touch the middle part of the heater during use, it gets very hot!

    Repeat until desired effect is achieved :wink:

    G43 in Bud's Shop:
    https://shop.vapelife.com/products/g43

    -----------------------------------------------------------------------------------

    G43 VAPORIZER HOW TO VIDEOS

    Mod Usage & Quick Start Guide:


    Healthstones for Concentrates:


    Deep Cleaning Tutorial:


    Heater Assembly:
  • Dr green thumb
    5.3k
    These are still great
  • Bad Dog
    100
    Very informative they answered alot of my questions about the G43
  • Hippie
    31
    Great setup and use vids

    I would also disable the modes you're not going to use in the Vaping > Modes menu

    Vaping > Prot. is the timer protection for normal use and set to 10s by default, increasing the Prot. time will increase the length of the timer bar you see at the top in autofire mode. It only goes up to 25s but I find it easier to keep an eye on session time with it set to 25

    To flip the display upside down - click 5 times to power the mod off (or whatever you have set for on/off in the interface>clicks menu) > hold plus and minus > click 5 times to switch the mod back on again.
    and the same to go back to normal view
bold
italic
underline
strike
code
quote
ulist
image
url
mention
reveal
youtube
tweet
Add a Comment

Welcome to Vape Life Forum!

Sign up free for full access to this site.